Chugger Stainless Brew Pump Inline XCPSS-IN-1 (115v)

Chugger Pumps are the most economical brewing pump on the market. All the materials are FDA food compliant and the components are UL Recognized.

This is the Inline Version where the inlet and outlet are 180 degrees opposed to each other. Designed and built by fellow homebrewers, these pumps provide an excellent addition to any brew setup. 7-8 Gallon flow per minute makes Chugger Pumps one of the industrys top performers!

This low velocity pumps is magnetic driven and therefore should not be run dry.  They will require the pump head and lines to be full before the pump is started.

Inlet 1/2` MPT Outlet 1/2`MPT. 316 STAINLESS STEEL (Front Housing). 316 Stainless Steel (Rear Housing) which contains a 2 7/8 diameter Ryton/Teflon Impeller designed to increase head pressure. Teflon (Thrust Washer). Clear Silicone (O-Ring) to prevent contamination from dyes in your brew. A ridge is also built into the casing to securely hold o-ring and prevent sealing problems. 4 Phillips Head screws hold both front housing and back housing making for easy assembly and disassembly.

Features:

• Full Ported Inlet (1/2) which will prevent cavitation problems
• 3/16 Polished End
• 0.04 Horsepower which makes the motor run significantly quieter
• Max Flow: 7 GPM 26.5 LPM
• Max Head: 18.6 FT 4.1 M
• Power: 1/20 HP (.04 HP) .029 KW
• Electrical: 115V 50/60HZ
• Non-Submersible
• Motor AMP Rating Full Load Amps (FLA)
• Motor and Pump: 1.4 Amps
• Can handle liquids of 250F

Materials are FDA Food Compliant
Components are UL Recognized
DO NOT RUN DRY